Tesla Supercharger V3 details: 250 kW, no charge splitting, twice as fast



Tesla launched its newest V3 Supercharger at an official unveiling event in Fremont, California, Wednesday night.

As we first reported, V3 Superchargers will be able to charge twice as fast the current generation Supercharger with a maximum power output of 250 kW or 1,000 miles per hour. Additionally, Tesla owners using V3 Superchargers will no longer need to split power with neighboring vehicles, thereby substantially increasing the charge rate and reducing the overall amount of charging time by nearly half.

Supercharger V3 details first surfaced Wednesday evening in Release Notes for a new over-the-air firmware update that went out to Model 3 owners, first captured by Erik @teslainventory on Twitter.

Tesla began to roll out the over-the-air firmware update to a small group of Model 3 owners that were invited to attend the official Supercharger V3 unveiling. Attendees are members of Tesla’s “Early Access Program” who will be one of the first to use Tesla’s next-generation Supercharger.

The firmware update went out ahead of the event to prepare these vehicles to accept the higher power output from Tesla’s newest ultra-fast chargers.

(adsbygoogle = window.adsbygoogle || []).push({});

some updates:You must update a special firmware to access sc v3 test sites. After the update It will popup on your map. pic.twitter.com/3ONzyH4OJp

— privater (@privater) March 7, 2019

“Your Model 3 is now able to charge at V3 Superchargers at up to 250 kW peak rates. Supercharger stations with V3 hardware are designed to enable any owner to charge at the full power their battery can take – no more splitting power with another vehicle connected to your cabinet. This combination of higher peak power and dedicated vehicle power allocation across the site enables you to charge in half the time.”

Tesla firmware release notes for Model 3 via Erik @teslainventory

Of note is the final sentence in the section for “Supercharger Improvements”, which indicates that the firmware update will allow a vehicle to condition its batteries before arriving at a V3 Supercharger station. “Also, when you navigate to a Supercharger, your call will condition its battery during the drive, so it can charge faster,” reads the release note.

Preconditioning a battery isn’t something new for Tesla vehicles, especially for P100D owners looking to ‘Bring it on!‘ with Ludicrous Mode. Being able to optimize the temperature of the battery cells allows them to be in a state that can operate at higher current and thereby charge at the higher 250 kW power.

At the moment, our understanding is that only Model 3, which utilizes a newer generation 2170 cell compared to the older 18650 form factor cell found in Model S and Model X, will be able to V3 Supercharge at full potential.

Be sure to check back as we will update the story with full details and specifications for Tesla Supercharger V3.

Update: Tesla published details for V3 Supercharging in a company blog post (included below). A video of the fast charging speed can be seen in their video.

Introducing V3 Supercharging

Tesla has more than 12,000 Superchargers across North America, Europe, and Asia and our network continues to grow daily: more than 99% of the U.S. population is covered by the network, and we anticipate similar coverage in Europe by the end of 2019. Recently, we passed 90% population coverage in China and are growing that number quickly. However, in order to drive continued electric vehicle adoption and further accelerate the world’s transition to sustainable energy, charging needs to be even faster, and the number of vehicles able to charge at a location in a day needs to be significantly higher. Today, we’re unveiling V3 Supercharging, the next step in the growth of Tesla’s Supercharger network. V3, which is born from our experience building the world’s largest grid-connected batteries, enables our vehicles to charge faster than any other electric vehicle on the market today.

Faster Charging, No More Power SharingV3 is a completely new architecture for Supercharging. A new 1MW power cabinet with a similar design to our utility-scale products supports peak rates of up to 250kW per car. At this rate, a Model 3 Long Range operating at peak efficiency can recover up to 75 miles of charge in 5 minutes and charge at rates of up to 1,000 miles per hour. Combined with other improvements we’re announcing today, V3 Supercharging will ultimately cut the amount of time customers spend charging by an average of 50%, as modeled on our fleet data.

Supercharger stations with V3’s new power electronics are designed to enable any owner to charge at the full power their battery can take – no more splitting power with a vehicle in the stall next to you. With these significant technical improvements, we anticipate the typical charging time at a V3 Supercharger will drop to around 15 minutes.

On-Route Battery WarmupNew Supercharging infrastructure isn’t the only way we are improving our customers’ charging experience. Beginning this week, Tesla is rolling out a new feature called On-Route Battery Warmup. Now, whenever you navigate to a Supercharger station, your vehicle will intelligently heat the battery to ensure you arrive at the optimal temperature to charge, reducing average charge times for owners by 25%.

This combination of higher peak power with V3, dedicated vehicle power allocation across Supercharger sites, and On-Route Battery Warmup enables customers to charge in half the time and Tesla to serve more than twice the number of customers per hour. Additionally, we are also unlocking 145kW charge rates for our 12,000+ V2 Superchargers over the coming weeks.

With Model 3 now shipping globally in high volumes and Model Y on the way, V3 Supercharging enables us to deliver the fastest production charging experience at an unprecedented scale compared to other electric vehicle manufacturers. By increasing the number of vehicles we’re able to charge at each Supercharger in a day, the investment we’re making in our network will go significantly further with every V3 station deployed. Paired with other savings, these efficiencies will translate to an increased pace of investment for Superchargers moving forward, with a continued focus on getting to 100% ownership coverage across all regions we operate. With thousands of new Superchargers coming online in 2019, the launch of V3, and other changes we’re making to improve throughput, the Supercharger network will be able to serve more than 2x more vehicles per day at the end of 2019 compared with today – easily keeping pace with our 2019 fleet growth.

Beginning today, we’re opening the first public beta site in the Bay Area, which will incrementally be made available to owners in Tesla’s Early Access Program. We’re launching V3 Supercharging for Model 3, our highest volume vehicle, and we’ll continue to expand access as we review and assess the results of millions of charging events. We will increase Model S and X charging speeds via software updates in the coming months. V3 Supercharging will roll out to the wider fleet in an over the air firmware update to all owners in Q2 as more V3 Superchargers come online. Our first non-beta V3 Supercharger site will break ground next month, with North American sites ramping in Q2 and Q3 before coming to Europe and Asia-Pacific in Q4.

The post Tesla Supercharger V3 details: 250 kW, no charge splitting, twice as fast appeared first on TESLARATI.com.

Buy Tickets for every event – Sports, Concerts, Festivals and more buytickets.com

Discover more from Teslas Only

Subscribe now to keep reading and get access to the full archive.

Continue reading